Retour à la veille

CVE-2026-74711

Publié : 22 août 2026
Modifié : 22 août 2026
Lien officiel NVD

Description détaillée

In the Linux kernel, the following vulnerability has been resolved: hwmon: (pmbus) Fix type confusion in notification logic Sashiko reports: At the start of the loop in pmbus_notify(), the code unconditionally casts every attribute to a struct sensor_device_attribute: drivers/hwmon/pmbus/pmbus_core.c:pmbus_notify() { for (i = 0; i < data->num_attributes; i++) { struct device_attribute *da = to_dev_attr(data->group.attrs[i]); struct sensor_device_attribute *attr = to_sensor_dev_attr(da); int index = attr->index; ... } However, data->group.attrs can contain other types like struct pmbus_samples_reg or struct pmbus_sensor, which only embed a base struct device_attribute. If da is a struct pmbus_samples_reg, dev_attr is the last member. Casting it to struct sensor_device_attribute and reading the index field appears to access memory past the end of the allocation, which might trigger a slab-out-of-bounds read. Additionally, if da is a struct pmbus_sensor, casting it causes the index field to overlap with the page, phase, and reg fields. Could this produce a garbage mask on little-endian systems that spuriously matches the target reg, page, and flags during an alert? Fix the problem by using struct sensor_device_attr in struct pmbus_sensor and struct pmbus_label. Since those attributes never trigger a notification, set the value of attr->index to -1 for them. Use this value to distinguish from boolean attributes which _can_ trigger a notification and use the index field to encode mask, page, and register values.

Références et Patchs

Dernières Vulnérabilités

CVE-2026-74733

In the Linux kernel, the following vulnerability has been resolved: gpio: pca953x: fix pca953x_irq_bus_sync_unlock regmap lock Locking is disabled in the regmap config as this driver uses its own lock. This means that all calls to regmap functions (read or write) must hold the i2c_lock. The function pca953x_irq_bus_sync_unlock() did not do this, and it was therefore possible that multiple threads could cause an incorrect register to be read/written. A previous patch partly fixed this, but only protected the write to the interrupt mask register, and not the read from the direction register.

VOIR DÉTAILS

CVE-2026-74732

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Check for tg ops in dce110_set_avmute Some older DCE timing generators do not implement is_tg_enabled in their ops table. Calling it unconditionally when waiting for AV mute frames causes a NULL pointer dereference on Southern Islands dGPUs when turning the display off over HDMI. Check that tg and the required ops exist before waiting for frames. (cherry picked from commit 2686a0c0aaa07bec2e24131835cf27b5fd4935a5)

VOIR DÉTAILS

CVE-2026-74731

In the Linux kernel, the following vulnerability has been resolved: sched_ext: Skip sub-disable teardown for never-linked sub-schedulers A sub-scheduler enable can fail before scx_link_sched() links the sched into the hierarchy, e.g. when the parent is already being disabled, and cleanup still runs the full scx_sub_disable(). That is racy against root disable: drain_descendants() is the only ordering between a sub's disable-time task walk and root disable's all-task teardown, and an unlinked sub is invisible to it. Root's teardown can thus run between the never-linked sub's drain and its walk, exiting every task to no scheduler. The walk then trips the membership WARN and re-homes the exited tasks onto the dying hierarchy, a use-after-free. Skip the cgroup ownership reset and the task walk if @sch was never linked, indicated by the empty ->sibling as unlinking only happens later in the same function. The membership WARN remains valid: a linked sub is always waited on by an ancestor's drain.

VOIR DÉTAILS