CVE-2026-74694
Description détaillée
In the Linux kernel, the following vulnerability has been resolved: net/ncsi: fix heap OOB read in NCSI_CMD_SEND_CMD payload length ncsi_send_cmd_nl() takes the number of bytes to copy from the attacker-controlled ncsi_pkt_hdr.length field of the in-band packet header, while the source buffer is the NCSI_ATTR_DATA netlink attribute whose readable size is nla_len() - sizeof(ncsi_pkt_hdr). The two length sources are never cross-checked: only nla_len() >= sizeof(struct ncsi_pkt_hdr) is enforced. With hdr->length set larger than the attribute payload (up to 65535 against at most 2032 readable bytes), ncsi_cmd_handler_oem() copies past the end of the netlink attribute buffer with unsafe_memcpy(), leaking up to ~64KB of kernel heap memory into the transmitted NCSI command packet. The destination skb is sized by the declared payload, so the write side does not overflow - this is a pure OOB read / information leak, reachable with CAP_NET_ADMIN on systems with a registered NCSI device (e.g. OpenBMC on Aspeed BMC SoCs, where NET_NCSI=y is standard). Reject commands whose declared payload extends past the end of the data attribute. The issue was found by the autokbug dynamic kernel fuzzer at Tencent Yunding Lab.
Références et Patchs
Dernières Vulnérabilités
CVE-2026-74733
In the Linux kernel, the following vulnerability has been resolved: gpio: pca953x: fix pca953x_irq_bus_sync_unlock regmap lock Locking is disabled in the regmap config as this driver uses its own lock. This means that all calls to regmap functions (read or write) must hold the i2c_lock. The function pca953x_irq_bus_sync_unlock() did not do this, and it was therefore possible that multiple threads could cause an incorrect register to be read/written. A previous patch partly fixed this, but only protected the write to the interrupt mask register, and not the read from the direction register.
CVE-2026-74732
In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Check for tg ops in dce110_set_avmute Some older DCE timing generators do not implement is_tg_enabled in their ops table. Calling it unconditionally when waiting for AV mute frames causes a NULL pointer dereference on Southern Islands dGPUs when turning the display off over HDMI. Check that tg and the required ops exist before waiting for frames. (cherry picked from commit 2686a0c0aaa07bec2e24131835cf27b5fd4935a5)
CVE-2026-74731
In the Linux kernel, the following vulnerability has been resolved: sched_ext: Skip sub-disable teardown for never-linked sub-schedulers A sub-scheduler enable can fail before scx_link_sched() links the sched into the hierarchy, e.g. when the parent is already being disabled, and cleanup still runs the full scx_sub_disable(). That is racy against root disable: drain_descendants() is the only ordering between a sub's disable-time task walk and root disable's all-task teardown, and an unlinked sub is invisible to it. Root's teardown can thus run between the never-linked sub's drain and its walk, exiting every task to no scheduler. The walk then trips the membership WARN and re-homes the exited tasks onto the dying hierarchy, a use-after-free. Skip the cgroup ownership reset and the task walk if @sch was never linked, indicated by the empty ->sibling as unlinking only happens later in the same function. The membership WARN remains valid: a linked sub is always waited on by an ancestor's drain.